High Definition For christmas melamine dinnerware to kazakhstan Factories

FAQ: 1.Q: Where is your factory located? How can I visit there? A: Our factory is located in Guangdong province, China. Warmly welcome to visit us! 2.Q: What is the material of your products? A: The material is melamine.  3.Q: How can I get some samples? A: We can send the samples by Express/DHL/FedEx/UPS etc. 4.Q: How does your company do regarding quality control? A: We have a very strict QC system. Our inspectors have been closely monitoring the production process from the selection of raw materials to the final step of the finished products. 5.Q: Can you print our logo on the product & packing? A: Yes, We can print your logo on our products.

It can rip, crosscut, and miter, and ‘swap’ between sawing and routing in seconds. Our new design is portable too! Plans and hardware available at http://www.a2equipment.com

Features:

• Precision extruded guide rails provide a stable and consistent cut (at least 1/32″ over four feet)

• Patented Gap Guides allows for sub 8 second tool changes

• Zero Offset Geometry allows the saw carriage to sit flush with the bottom of the guides, maximizing the depth of cut

• Crystal Clear and ultra tough polycarbonate carriages lets you see your work

• Easy to add a miter fence for accurate miter cuts

• Ultra low friction bearing lower support eliminates rollers, reducing complexity and enabling easy cutting of materials like lattice work

First off I took this design from “The Family Handyman” and altered she size to fit my needs. I will post a diagram of the original plans on my Facebook page if you would like to see them. Easy and professional looking. I made several of these units, some of different widths to fit my garage running almost the full length of the garage wall. I made then as tall as my shelfs that are hanging from the ceiling(you can check that video out if you later).

Building plans:

https://www.facebook.com/Code3Imagination/posts/827676224064905

Here is what you will need for this project

Required Tools for this Project

Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.

Clamps
Cordless drill
Circular saw or jigsaw
Stud finder (if you walls are finished and painted)
Bolt cutter
Level
Flush trim knife for the edge banding, if needed

Required Materials for this Project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.

3/4″ x 11-3/4″ x 8’ melamine shelf board (2) or use full 4′x8′ sheets to cut to length if making multiple units
3/4″ x 15-3/4″ x 37-1/2″ melamine shelf board (1), I had old melamine shelves and used them(bonus)
White edge banding for unfinished edges.
3/4″ x 2-1/2″ x 8′ pine boards (3) or 2″x6″x10′ ripped and cut down to sizes(saved